The Sound Indicators - AEI HA-266 Owner's Manual

THE SOUND INDICATORS

SOUND
!
1 short beep Successful key entry, a pacifier tone
!
2 short beeps Successful code entry for the specific function
!
5 short beeps Unsuccessful code entry for the specific function
!
Wrong code number entered
!
Unauthorized command attempted
!
Code entry time expired, 10 seconds maximum per digit is allowed
!
1 long beep Exit delay expired, system is armed
!
1 short beep/30 seconds
Battery voltage low, AC power failure
!
Continuous beeping at Exit delay time
!
0.5 second interval Entry delay time
!
The DAP jumper is ON
!
Continuous 5 short The telephone line is faulty after line fault testing
beeps/5 seconds interval
!
2 beeps + 5 beeps System can not be armed instantly due to
!
Duress code is entered but the communicator is not working
8
THE SYSTEM CONTROL CONSOLE AND ITS INDICATORS
MEANING
ARM PROHIBITED
ALARM REPORTING AND ACKNOWLEDGEMENT
!
In alarm condition, except the local alarm, the system will also send alarm report to the
monitor station and the recorded message to the programmed telephones if the
communicator and the auto dialer are enabled.
!
The communicator has the priority to dial. After the communicator dialing is finished, the
system will start to dial the telephone numbers stored in the auto dialer.
!
If VOICE MESSAGE
is through.
RECEIVE AN ALARM REPORTING MESSAGE AND GIVING ACKNOWLEDGEMENT
Please put a " " in the box showing your selected option:
NON-BACKUP REPORTING
BACKUP REPORTING
1) When you pick up the phone, you will hear the recorded alarm reporting message (
seconds) . At the end of the message, the dialer generates a BEEP tone and then waits 3
seconds for you to acknowledge.
2) The acknowledgement signal can be given by pressing the [1] button on your telephone
must be a tone dialing telephone)
1 - - - - - - - - -
3) Without an acknowledgement, the message will be repeated until the maximum number of
message is reached. The dialer will call the remaining numbers and will then retry the
numbers that did not acknowledge repeatedly until the maximum number of dialing attempts
are reached.
4) On BACKUP
telephone in a group of 4
consider the current event closed and call off the dialer session. The remaining 3 telephones
are there for backup purposes only.
5) On NON-BACKUP
telephone in the group of 4
to be reported and closed.
HA-266
HA-266
is selected, the auto dialer will send the recorded message after the line
OPTION
SELECTED
OPTION
SELECTED
after the BEEP within 3 seconds.
ON YOUR TELEPHONE KEYBOARD
reporting mode, receiving an acknowledgement signal from a SINGLE
(the dialer can store 4 telephone numbers maximum)
reporting mode, an acknowledgement signal must be received from each
(if 4 numbers are stored) before the current event is considered
(DEFAULT)
20
(it
is sufficient to
69