Table of Contents
Advertisement
24-HOUR MONITORING AND ALARM REPORTING
The following options are available for alarm reporting. With the option selected, the system will
transmit the alarm signal and/or voice message to the monitor station and/or to the telephones
programmed accordingly when alarm occurs or when operation status changes.
Please put a "
" in the box showing your selected option:
COMMUNICATOR AND VOICE DIALER
With this option selected, no status report or voice message will be sent
COMMUNICATOR AND VOICE DIALER
With this option selected, both status report and voice message will be sent when alarm occurs.
COMMUNICATOR
"OFF"
, VOICE DIALER
With this option selected, only voice message will be sent when alarm occurs.
COMMUNICATOR
"ON"
, VOICE DIALER
With this option selected, only status report will be sent when alarm occurs.
60
OPTION
"OFF"
SELECTED
.
OPTION
"ON"
SELECTED
OPTION
"ON"
(DEFAULT)
SELECTED
OPTION
"OFF"
SELECTED
RECORDING THE CLIENT CODE
LOCATION
10
!
The client code is the client's identification number, it must be programmed with 4 digits.
The system will reject the code if it is not exact 4 digits.
!
The client code is not necessary if the alarm system is not linked to the monitor station.
!
When a new code is entered, the old code will be replaced.
!
The default value of the client code is 0000.
RECORDING THE USER CODES
LOCATIONS
11
!
LOCATIONS:
11=User Code 1
12=User Code 2
13=User Code 3
14=User Code 4
!
The user codes can be 2 digits minimum to 5 digits maximum.
!
User code 1 is also the authorization code of the system to accept remote arm-disarm
control from any DTMF telephone.
!
Usually only one user code is required to arm-disarm the system.
!
Programming of the user codes 2 to 8 is optional, unless more than one users are required
to operate the alarm system.
!
When a new code is entered into the location, the old code will be replaced.
!
To invalid a code, just key-in the specific location number followed immediately by the [#]
key without program data.
HA-266
HA-266
CLIENT CODE
VALIDATION
4 DIGITS
#
USER CODES
VALIDATION
2 TO 5 DIGITS
#
(Also the code for remote control)
15=User Code 5
16=User Code 6
17=User Code 7
18=User Code 8
PROGRAMMING THE PANEL
(Location: 10)
(Locations: 11-18)
17
Advertisement
Table of Contents
