Terminal Definitions And Descriptions; The Terminals On Printed Circuit Board - AEI HA-266 Owner's Manual

!
The new telephone number is accepted. It can be 32 digits maximum.
!
The message form is 1 VOICE MESSAGE ,
pager, the message form 0 , NUMERIC MESSAGE
INSTALLATION SECTION, " Dialing to an auto-pager station from the dialer"
!
If the programming is rejected, 5 beeps will be generated. Try again.
3) Exit the programming mode by pushing [ ] [ ]
!
System is back to operation mode.
DELETE A TELEPHONE NUMBER IN AUTO-DIALER
If a telephone number is no longer valid for alarm reporting, and you do not have a new
number to replace it, it is best to delete it. The auto dialer will skip the empty location to speed
up the dialing attempt cycles.
1) Enter your [MASTER CODE] and validate by [ ] [ ]
MASTER CODE
!
The PROGRAM light comes ON.
2) Enter the telephone location [60-63] you wish to delete its telephone number and
validate by [#].
TELEPHONE LOCATION #
!
The telephone number in that location is deleted.
!
If the request is rejected, 5 beeps will be generated. Try again.
3) Exit the programming mode by pushing [ ] [ ]
!
System is back to operation mode.
68
CHANGE AND DELETE
. (If you wish the system to contact an auto-
should be selected. Please see
for details).

TERMINAL DEFINITIONS AND DESCRIPTIONS

THE TERMINALS ON PRINTED CIRCUIT BOARD

HA-266 HA-266
WHITE/BROWN
YELLOW GREEN
BROWN
ORANGE
WHITE/RED
PURPLE
BLUE
WHITE/BROWN
PINK
WHITE
YELLOW
+12V UNSWITCHED O/P (+) 12V
LIGHT BLUE
OPTIONAL ARM-DISARM CONTROL SWITCH
GREEN
(MOMENTARY N.O. TYPE)
+12V OUTPUT AT ALARM CONDITION
GREY
( ) GROUND -
BLACK
+12V OUTPUT AT NORMAL CONDITION
RED
12 16V INPUT POWER -
RING
TELEPHONE SET
TIP
EARTH
RING
TELEPHONE LINE
TIP
ZONE 6
ZONE 5
ZONE 4
ZONE 3
ZONE 2
ZONE 1
( ) GND -
DATA
CLOCK
9