Table of Contents
Advertisement
3. USE THE DAP JUMPER DIRECTLY ACCESS TO PROGRAMMING MODE
If the factory set master code was deleted and the personal master code is forgotten. Use the
DAP jumper to override the forgotten code permitting direct entry into programming mode. The
DAP jumper can be found on the master circuit board. The owner is required to apply the
following procedures precisely when use the DAP jumper:
ON
DAP
i ) Disconnect the power supply.
ii ) Displace the DAP jumper from OFF to ON position.
iii ) Reconnect the power supply, the console will beep continuously.
iv ) Put the DAP jumper back to OFF position, the beep stops and the
v ) The system is in programming mode now, and it is ready to receive new data.
vi ) The DAP jumper is normally left on OFF position after programming.
START THE PROGRAMMING
After the system is set in programming mode, you can start to program the system with your
desired programming values. You can make the programming for all the program options
continuously or just select those options that you require. It is not necessary to make the
programming in order sequence; you can jump to any
in the system.
RECORDING THE MASTER CODE
LOCATION
MASTER CODE
0 1
2 TO 5 DIGITS
!
The master code can be 2 digits minimum to 5 digits maximum.
!
When the new personal master code is entered, the factory set master code or the code
that was programmed will be erased
16
PROGRAMMING THE PANEL
OFF
PROGRAM
Programming Location
VALIDATION
#
.
MAKE A PANIC ALARM
At anytime, hold down any TWO key buttons on the control console simultaneously for three
seconds will trigger an alarm. The console will give 2 beeps to confirm the alarm condition.
!
Local alarms will be given.
!
Communicator
!
The dialer
LED is ON.
message.
!
There will be no indication of an alarm condition on the control console.
MAKE A DURESS ALARM
This feature is available ONLY at the condition that the communicator or the dialer is enabled.
Otherwise, making a duress alarm is not possible.
that is available
Should an intruder force you to turn your security system OFF, you can send a silent DURESS
alarm signal to the monitor station and send the recorded message to the programmed
telephones.
The duress code is made by adding 2 to the 1st digit of your USER CODE(s). For example, if
(Location: 01)
your User Code is [1357], enter [3357] will trigger a silent alarm
Enter your [DURESS CODE], and validate by [#] key.
!
No local alarm will be given.
!
Communicator will send a duress alarm report.
!
The dialer will contact the programmed telephones and send the message.
!
There will be no indication of an alarm condition on the control console.
!
The system will be turned
!
The system will keep itself in
HA-266
HA-266
EMERGENCY CASES
(A Software Zone)
ANY TWO KEY BUTTONS ON THE CONTROL CONSOLE
(if enabled)
will send a panic alarm report.
(if enabled)
will contact the programmed telephone numbers and send the
(A Software Zone)
DURESS CODE
#
OFF
if it is in
ARMED
OFF
condition if it is
(Duress)
.
or in
ALARM MEMORY
condition.
OFF
.
61
Advertisement
Table of Contents
