Programming The Panel; How To Enter Programming Mode; Use The Factory Set Master Code; Use Your Own Master Code - AEI HA-266 Owner's Manual

6-zone alarm control panel with auto-dialer and communicator

Hide thumbs

Table Of Contents

Table of Contents

TEST YOUR SYSTEM

Please make sure that the system is in DISARMED mode when you perform the tests.

STANDBY BATTERY TESTING ROUTINES

The system can be programmed to perform dynamically and automatically test of its standby

battery with the options of periodic test and manual test.

The test takes 2 minutes. The

BATTERY

AC power is turned OFF in order to monitor the battery under load during the test.

Two beeps will be generated and the

If the battery is low or dead, five beeps will be generated, the

control console will continuously generate the warning signal of one short beep per 30

seconds until the next test.

A battery status report will be sent to the monitor station on the following two testing results

if the communicator is enabled:

1) The battery is

LOW

A battery

2) The battery resumes

NORMAL

but it was

No report will be given if the battery is normal in this test and it was also normal in the last

test.

NOTE:

1) The system will refuse to initiate the standby battery dynamic test in alarm condition, or, in

the condition of AC power failure, but the system will send a battery low report automatically

before battery exhausting if the battery is

2) The standby battery should be replaced every two to three years with a rechargeable 12V,

1.2Ah, lead acid battery.

TEST THE BACK-UP BATTERY -- PERIODIC

The system can be programmed with the following options for periodic testing of the back-up

battery, please put a "

" in the box showing your selected option:

DAILY (EVERY 24 HOURS) BATTERY TEST ENABLED

WEEKLY (EVERY 7 DAYS) BATTERY TEST ENABLED

PERIODIC BATTERY TEST DISABLED

The counting of the periodic test starts at the time when the system is power-up

or DC power is firstly connected)

The time counting of the periodic test is not affected by the manual battery test.

LED will flash during the test.

BATTERY

LED will be OFF if the battery is normal.

BATTERY

LED will be ON. The

LOW

report.

LOW

A battery

NORMAL

LOW

lasting for more than two minutes.

OPTION

SELECTED

OPTION

SELECTED

OPTION

SELECTED

You may program the panel from the system control console. Firstly, you are required to make

the system in programming mode, then key in the two digit

address

, followed immediately by the desired programming values

the [#] key to store the data. The console will beep twice to confirm the data is successfully

stored, and that 5 beeps will be generated for unsuccessful data entry. If you are not sure that

the correct programming values have been entered, program the programming location again.

After programming is finished, press the [ ] key twice to leave programming mode.

The maximum allowable time for each digit entry is 10 sec

ATTENTION:

Please make sure that the alarm control panel is firmly fixed to the metal box before

applying power to the system. Otherwise, the tamper switch will be triggered instantly to

give alarm and there will be no user code available for turning off the alarm before the

system is programmed.

HOW TO ENTER PROGRAMMING MODE

report.

1. USE THE FACTORY SET MASTER CODE

For the owner's convenience in programming at the first time, the factory has put a Master Code

1234 into the system. The owner can use this code for the system to enter to programming mode.

To compromise security, in all cases, the owner should program a personal Master Code to

invalidate the factory set Master Code.

The console will beep twice to confirm that the system is in programming mode.

The

PROGRAM

2. USE YOUR OWN MASTER CODE

In the case that the factory set Master Code was replaced by your own Master Code, you have

to use your personal Master Code to enter to programming mode.

(DEFAULT)

The console will beep twice to confirm that the system is in programming mode.

The

PROGRAM

(when AC

HA-266