How To Assemble Your Ceiling Fan Blades; How To Assemble Your Light Kit Or Cap - Fanimation KLINCH FPS7679 Series Manual

How to Assemble Your Ceiling Fan Blades

1. Secure the blades to the bottom of the motor
assembly using the 3/16"-24 serrated head screws
and blade plates. Be sure the groove in the flywheel
is lined up with central hole on the blade. (Figure 1)
NOTE: Periodically check blade hardware and
resecure if necessary.
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.

How to Assemble Your Light Kit or Cap

1.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
Option A--for use with steel cap
NOTE: If installing the light kit, please skip to Step 4.
2. Assemble the light kit wire cover to the support
bracket of the motor assembly using the two key slots
in the light kit wire cover. Replace the previously
removed screw and securely tighten all three screws.
(Figure 2)
3. Assemble the steel cap to the light kit wire cover by
twisting in a clockwise direction. (Figure 3)
Groove
3/16"-24
Serrated Head Screws
Motor
Assembly
Steel Cap
11
3/16"-24 Serrated
Head Screw
Figure 1
Blade (3 each per blade)
HARDWARE USED:
Figure 1
Figure 2
Figure 3
Motor Assembly
Blade Plate
x 9
Light Kit
Wire Cover
Light Kit
Wire Cover