How To Hang Your Ceiling Fan - Fanimation KLINCH FPS7679 Series Manual

52 ceiling fan

Hide thumbs

Table of Contents

Available languages

WARNING

To avoid possible electrical shock, be sure electricity

is turned off at the main fuse box before hanging.

(Figure 1)

NOTE: If you are not sure if the outlet box is grounded,

contact a licensed electrician for advice, as it must be

grounded for safe operation.

WARNING

The fan must be hung with at least 7´ of clearance

from floor to blades. (Figure 2)

WARNING

It is critical that the outlet box and the screws are

securely anchored to the building structure and

capable of withstanding a load of at least 35 lbs.

Failure to verify that the screws are properly installed

could result in the fan falling.

CAUTION

Do not connect fan blades until the fan is completely

installed. Hanging fan with blades connected may

result in damage to the fan blades.

Securely attach the outlet box acceptable for ceiling

fan support into the building structure. Outlet box is

not supplied with the fan. (Figure 3)

Remove the four screws and hex nuts from the

ceiling plate assembly. Retain the screws and hex

nuts for later. (Figure 4)

Using the

3/8"

x 2" lag bolt and flat washer, attach

safety cable to ceiling joist or wood structural member.

The lag bolt will pass through the flat washer, safety

cable loop, and into the building structure (Figure 5).

You will first drill a 1/4" pilot hole into the building

structure to prevent splitting or cracking.

The ceiling support cable need to pass through the

center hole of ceiling plate assembly when mounting.

Using the two #8-32 screws and washers securely

attach the ceiling plate assembly to ceiling outlet box

as shown. (Figure 5)