How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation EIGHTYFOUR LP6827LBN Instruction Manual

How to Install Your Canopy Housing

NOTE: This step is applicable after the necessary
wiring is completed.
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care not
to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and
the ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)

How to Assemble Your Ceiling Fan Blades

CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Position blade over the hub of motor assembly with
the threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the hub of
motor assembly and tighten 3/16˝-24 truss head
screw with spring washer/flat washer. (Figure 1)
Shoulder Screw
Motor Assembly
Blade
3/16˝-24 Truss
Head Screw with
Spring Washer/
Flat Washer
(3 each per blade)
3/16"-24
Truss Head Screw
with Spring Washer/
Flat Washer
12
Figure 1
Figure 2
Figure 1
HARDWARE USED:
Ceiling
Canopy
Canopy Screw
Cover
x 27