How To Assemble Your Ceiling Fan Blades - Fanimation KLEAR FPD6858 Series Manual

How to Assemble Your Ceiling Fan Blades

CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1.
Position blade along the motor, aligning blade
holes with holes in the top of the motor assembly
flywheel. Make sure the blade is fully seated against
the flywheel and install 3/16˝-24 truss head screw
with spring washer/flat washer and blade plate.
Don't fully tighten at this time. (Figure 1)
2.
Install and securely tighten 3/16˝-24 truss head
screw with spring washer/flat washer at the underside
of the blades, then securely tighten all previously
installed screws on top of motor. (Figure 2)
Blade Plate
HARDWARE USED:
3/16"-24
Truss Head Screw
with Spring Washer
/Flat Washer
Motor
Assembly
3/16˝-24 Truss Head Screw
with Spring Washer/Flat Washer
(2 each per blade)
HARDWARE USED:
3/16"-24
Truss Head Screw
with Spring Washer
/Flat Washer
7
3/16˝-24 Truss Head Screw
with Spring Washer/Flat Washer
(2 each per blade)
Blade
Figure 1
x 6
Figure 2
x 6
Blade