Unpacking Instructions - Fanimation KLINCH FPS7679 Series Manual

This manual is designed to make it as easy as possible for you to assemble,
Tools Needed for Assembly
(Not Included)
• One Phillips head screwdriver
• One ¼˝ blade screwdriver
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 9). If you feel you
do not have enough wiring knowledge or experience, have
your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all steps have been
completed and will be helpful in finding your place should you be interrupted.
Do not install or use fan if any part is damaged or missing. This product is designed to use only those parts supplied with
this product and/or any accessories designated specifically for use with this product by Fanimation. Substitution of parts
or accessories not designated for use with this product by Fanimation could result in personal injury or property damage.
Contact your retail store for missing or damaged parts.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to exploded view illustration.
Ceiling Plate Assembly (1)
Motor Assembly (1)
Hardware Bags
3/16˝-24
Serrated Head Screws
(10)
install, operate and maintain your ceiling fan
• One stepladder
• One wire stripper

Unpacking Instructions

Upper Housing (1)
Blade Set (1)
Safety Cable Kit
Wire Connectors
(4)
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
nstalled
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing, contact your local retailer.
WARNING
Light Plate Assembly (1)
Light Kit/Glass Assembly (1)
Safety Cable Cable Clamp
(1) (1)
4
Materials
ire ength
p to ft
ft
Light Kit Wire Cover (1)
Hand-held Remote (1)
Wall Holder (1)
Screws (2)
Steel Cap (1)
Battery (1)
Blade Plate Set (1)
Receiver (1)
Wire Connectors (6)
Flat Washer, Lag Bolt
Stainless Steel (1)
(1)
ire i e
12V 23A