How To Wire Your Ceiling Fan - Fanimation KLINCH FPS7679 Series Manual

NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
1. To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. (Figure 1)
NOTE: Factory setting is all up. Do not use this
position.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION WILL
DAMAGE THIS RECEIVER.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
GROUND
L
AC POWER
N
L1
2. Connect green wires from ceiling plate assembly and ground from supply using wire connector. Connect black
wire from receiver unit marked "AC IN L" to black supply wire using wire connector. Connect white wire from
receiver unit marked "AC IN N" to white supply wire using wire connector. Connect white wire from receiver unit
marked "TO MOTOR N" to white wire from fan using wire connector supplied with receiver unit. Connect black
wire from receiver unit marked "TO MOTOR L" to black wire from fan using wire connector supplied with receiver
unit. Lastly, connect blue wire from receiver unit to the blue fan light wire using wire connector supplied with
receiver unit. (Figure 3)
NOTE: If you feel that you do not have enough
electrical wiring knowledge or experience, have your
fan installed by a licensed electrician.

How to Wire Your Ceiling Fan

GREEN
BLACK
WHITE
RED
BLACK
WHITE
RF ANTENNA
Receiver
CEILING PLATE
BLUE
BLACK
WHITE
Figure 3
Wire
Connectors
9
Remote Control
Dip Switch
ON DIP
1 2 3 4 5
Figure 1
Main Fuse Box
Figure 2
BLUE
BLACK
WHITE
AC MOTOR
WHITE BLUE
LIGHT KIT
HARDWARE USED:
x 7