Advertisement
Zivko Edge 540 V3 - 92" wingspan 60-70cc
2.
3.
4.
3x15mm
5.
30
Instruction Manual.
APPLY THE DECALS
If all the decals are precut and ready
to stick. Please be certain the model is
clean and free from oily fingerprints and
dust. Position decal on the model where
desired, using the photos on the box and
aid in their location.
If all the decals are not precut, please use
scissors or a sharp hobby knife to cut the
decals from the sheet. Please be certain
the model is clean and free from oily fin-
gerprints and dust. Position decal on the
model where desired, using the photos on
the box and aid in their location.
BALANCING
An important part of preparing the
aircraft for flight is properly balancing
the model.
1) Attach the wing panels to the
fuselage. Make sure to connect the leads
from the aileron to the appropriate leads
from the receiver. Make sure the leads are
not exposed outside the fuselage before
tightening the wing bolts. Your model
should be flight-ready before balancing.
2) The recommended Center of Gravity
(CG) location for your model is (165mm)
back from the leading edge at the center
of the wing.
3) When balancing your model, make
sure it is assembled and ready for flight.
Support the plane upright at the marks
made on the wing with your figers or a
commercially available balancing stand.
This is the correct balance point for your
model.
Advertisement
