Feed one rudder cable through the pre
installed cable exit tube in the rear of the
fuse toward the front of the fuse. Repeat
for other side.
11.
Thread cable through brass swage tube.
12.
Thread cable through the threaded
co pler hole, and back through the brass
swage tube as shown.
Loop the cable back through the brass
swage tube and pull tight.
13.
14.
Crimp the brass swage tube with a
crimping tool or pliers.
15.
Cut off excess cable as shown.
16.
Attach ball links to the rudder servo arm
and then attach the servo arm to the rud-
der servo as shown.
15