Shimano SC-EN600 Dealer's Manual page 34

Installation/removal
Wiring around the cockpit (clamp band type cycle computer)
1. Wire around the cockpit.
Connect the cycle computer and the switch units using the electric wires.
A switch unit, satellite system ON/OFF switch, or drive unit can be connected to any of the E-TUBE ports on
the cycle computer. However, it is recommended to connect as shown in the figure.
Cycle computer
Left switch
To drive unit or satellite
system ON/OFF switch
2. Prepare to wire to the drive unit.
Refer to the " SHIMANO STEPS Dealer's Manual
When connecting to a satellite system ON/OFF switch, refer to the "
Dealer's Manual ."
Right switch
" when directly connecting to a drive unit.
34
SHIMANO STEPS Special Battery Parts