Table of Contents
Advertisement
LCD display
Error name
Cut sheet feed error
Auto-cutter error
Cartridge recognition error
Error details
Double-feed of cut sheets.
This could be due to the rea-
sons below.
• Cut sheets were inserted
upside down or back-
wards
• Confirmation mode is
configured so this condi-
tion causes an error
• Generation of noise by
MICR was detected
• Specified print data is lon-
ger than the cut sheet
length
The auto cutter home posi-
tion cannot be detected.
Ink information writing is not
be performed correctly.
Chapter 6 Troubleshooting
Solution
• If cut sheets were inserted
u p s i d e d o w n o r b a c k -
wards: Orient cut sheets
correctly when loading
them.
("Loading Cut Sheets" on
page
76)
• When the confirmation
mode is configured so this
condition causes an error:
Follow the instructions
provided by the applica-
tion.
• When generation of noise
by the MICR was detected:
Scan again.
• When the specified print
data is longer than the cut
sheet length:
Specify print data that is
shorter than the length of
the cut sheets.
Remove the jammed roll
paper or the foreign matter
from inside the roll paper
cover. With the roll paper
cover closed, turn the prod-
uct back on.
Check if the ink cartridge is
installed correctly.
(
" I n s t a l l i n g t h e I n k C a r -
tridges" on page
40)
Or you should replace the ink
cartridge with a new one.
(
" R e p l a c i n g t h e I n k C ar -
tridges" on page
74)
87
Advertisement
Table of Contents
