Table of Contents
Advertisement
Initializing Interface Settings
The following procedure allows you to restore the interface settings to their factory defaults.
Only the network settings are initialized.
1
Make sure the printer is turned off and the roll paper cover is closed.
2
Remove the connector cover if it is attached.
For information on how to remove the connector cover, see
page
45.
3
While holding down the status sheet button, turn on the product.
A message saying starting the initialization is printed and the product restarts.
Keep pressing the status sheet button until the initialization start message is printed.
Scanning Demonstration (network mode only)
Enter the IP address of the product followed by /demo in your web browser to launch Scan Demo.
http://xxx.xxx.xxx.xxx/demo
Chapter 3 Advanced Product Use
"Attaching the Connector Cover" on
63
Advertisement
Table of Contents
