Table of Contents
Advertisement
Stratford Fireplace Installation and Operation Manual
To complete the installation, make a hole of1/4" to 1/2" (6 mm à 13 mm) bigger than the insulate pipe
diameter in the outside wall of the house at the chosen location. From outside, place the outside air inlet
cap in the hole (open side down) and fasten the register to the wall, with screws as shown bellow. Place
the insulated pipe over the register tube and over the fireplace outside air connector. At each end, carefully
pull back the insulation and plastic cover, exposing the flexible pipe. Attach the flexible pipe using pipe
clamps. For a better seal, you may also use aluminum tape. Wrap the tape around the joint between the
flexible pipe and the air inlets. Carefully push the insulation and plastic cover back over the pipe. Fix the
plastic in place using aluminum tape.
__________________________________________________________________________ 79
Advertisement
Table of Contents
