YASKAWA MP2000 Series Troubleshooting Manual page 35

From the
A1
previous page
"---" (no display) is
displayed in the Transmission
Status field.
YES
Set the connection
parameters on the
Parameter Setting tab
page of the module detailed
definition window.
For details, refer to 3.3.2
Checking the Connection
Parameters.
Save the data to the flash
memory and turn the
power OFF and back ON.
Check the Connection
Type field in the module
detailed definition window.
TCP is displayed
in the Connection Type
field.
YES
(When using
the TCP protocol)
B1
NO
IDLE is displayed
in the Transmission
Status field.
Perform the following operations.
Create a message function.
Execute the message function.
Set the inputs and parameters
for the message function
properly.
Check the following.
The remote device exists and
the power to the remote device
NO
is turned ON.
After setting the parameters,
(When using
the data has been saved to
the UDP protocol)
the flash memory and the
power has been turned OFF
and back ON.
3.1 Flow for Checking Trouble
A2
NO
YES
For details, refer to 3.3.3
Checking the Message
Function.
B2
To the next page
3
3-3