Operating Your Radio - Fm - Roberts Gemini RD-45 User Manual

Operating your radio - FM

1. Carefully extend the telescopic aerial.
2. Press and release the On/Off button to switch on your radio.
3. Press and release the DAB/FM button to select the FM mode.
4. Press and release the Tuning Up button and then press and release
the Auto Tune button. Alternatively press and hold the Tuning Up
button for 2 - 3 seconds. Your radio will scan in an upwards direction
(low frequency to high frequency) and stop automatically when it fi nds
a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
6. Press and release the Tuning Down button and then press the Auto
Tune button. Alternatively press and hold the Tuning Down button
for 2 - 3 seconds. Your radio will scan the FM band in a downwards
direction (high frequency to low frequency).
7. When the waveband end is reached your radio will recommence tuning
from the opposite waveband end.
8. Rotate the Volume control to the required setting.
9. To switch off your radio press and release the On/Off button.
13
2,9
3
4
6
4,6
Note: If you fi nd that FM reception is poor, try repositioning the Telescopic
aerial. Fully extend and position vertically for optimum reception. If you
fi nd that an FM broadcast has a lot of background hiss, this may often
be reduced by setting the radio into Mono reception mode for the current
FM station. Please refer to the section 'FM Stereo/Mono' on page 15 for
further details.
FM
Mode
103.40MHz
Searching...
89.30MHz
Searching...