Roberts Stream 94L Manual page 13

Connecting to your computer network - cont.
3. To use a WiFi connection, you will first need to identify your network in the list of
network names presented by the Network Wizard. If no networks are found then you
may have to get your wireless router working (please see the instructions supplied
with it) or you may be too far from the router.
When the radio finds your wireless network, it displays the Network Name (SSID)
for the wireless access point on the screen. This is a name that is allocated to the
access point in your router by the person who set up the network - for example: 'Jones
family' or 'Paul's network'. Routers supplied by Internet Service Providers often have
the default name of the WiFi network provided on a label or card for easy reference
(e.g. BTHub - 1234, virginmedia 1234567). If the router supports WiFi Protected
Setup, then '[WPS]' will be shown in front of the SSID.
It is possible, and in some locations highly likely, that your radio will find more than
one wireless network, in which case you should choose which one you need to
connect to.
4. Rotate Tuning to see the SSID for each wireless network that has been found. If
your network is shown proceed to step 6 on the next page. If it is not shown then
proceed to step 5, also on the next page.
If you make a mistake at any point, use the Back button to go back to the previous
screen.
60
DAB
Configuration
Network Settings
Network Wizard
Scanning...
SSID
Jones family
[WPS] Paul's network
Smith
Brown
[Rescan]
[Manual config]
12