Product-Specific Safety Instructions - Bosch Rexroth SB11 Instruction Manual

Safety instructions | Load-sensing control block SB11
• If unsuitable products are installed or used in safety-relevant applications,
unexpected operating conditions may occur in the application, which could result
in personal injury or property damage. For this reason, only use the product
in safety-relevant applications if this use is expressly indicated and approved
in the product documentation, e.g. in safety-related parts of a control system
(functional safety).
• Only commission the product if it has been determined that the end product
(e.g. machinery/system) in which the Rexroth products are installed corresponds
to the country-specific provisions, safety regulations and standards for the
application.
• Use tools appropriate for the work being performed and wear appropriate
protective clothing to prevent punctures and cuts.
2�6 Product-specific safety instructions
The following safety instructions apply for chapters 6 to 14.
Danger due to suspended loads!
Risk of death or injury, or property damage!
In the event of inappropriate transport, the control block/control block segment
may be dropped and cause injury, e.g. bruises or fractures and/or damage to
the product.
▶ Make sure that the lifting capacity of the lifting device is sufficient to safely
bear the weight of the control block/control block segment.
▶ Never step or grip under suspended loads.
▶ Ensure a stable transport position.
▶ Use your personal protective equipment (e.g. safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶ Use suitable lifting devices for transport.
▶ Observe the prescribed position of the lifting strap.
▶ Observe the national laws and regulations on occupational health and safety,
and transportation.
System/machine under pressure!
Danger to life or risk of injury, severe bodily injury when working on machines
which have not been put to a standstill! Property damage!
▶ Switch off the entire system and secure it against reactivation according to the
parameters provided by the machine/system manufacturer.
▶ Ensure that all relevant components of the hydraulic system are depressurized.
For this purpose, observe the parameters indicated by the machine/system
manufacturer.
▶ Please note that the hydraulic system might still be pressurized even after
separation from the actual pressure supply.
▶ Do not disconnect any line connections, ports or components as long as the
hydraulic system is under pressure.
WARNING
RE 66177-B/2022-05-03, Bosch Rexroth AG
11/60