DPS Telecom TempDefender G2 User Manual page 8

2
Common Applications for the TempDefender G2
The TempDefender G2 reports alarms as SNMP traps over LAN and supports DCP polling over RS-232, RS-485 or
LAN. The TempDefender G2 supports simultaneous SNMP and DCP operation.
The TempDefender G2 supports both LAN and serial port connectivity. The LAN connection and serial port can be
used at the same time to support simultaneous SNMP and DCP alarm reporting. However, only one DCP channel
can be used, therefore the TempDefender G2 cannot simultaneously report DCP over LAN and DCP over serial port
connection.
In addition to its 8 discrete input points, the TempDefender G2 has 3 control relays, all form A, user defined NO/NC
with short, 8 analogs, and dwire. The control relays allow network administrators to respond remotely to threats to
system integrity. Using the control relays, network administrators can turn on backup generators, open doors and
gates for emergency access, reboot equipment, or perform other functions. The TempDefender G2 also allows you to
reverse the logic state of the alarm on a point by point basis for discrete alarms.
Another feature of the TempDefender G2 is user-defined alarm qualification times. This will allow you to clearly
distinguish momentary status changes from serious problems.