Figure 51: List Dui Diagnostic/Update Services And Functions - Advantech FWA-T011 Getting Started Manual

function 0: upgrade, FRU EEPROM upgrade function
service 20: SAS_BIOS_UPD, SAS BIOS update service
function 0: upgrade, SAS BIOS upgrade function
service 21: SAS_FW_UPD, SAS Firmware update service
function 0: upgrade, SAS Firmware upgrade function
service 22: ATF, A diag service to run ATF test program/cases

Figure 51: List DUI Diagnostic/Update Services and Functions

Please note that DUI is designated to contain universe set of all diagnostic items, which
implies that not all of service is available in a particular platform. For example, BMC related
items may not be applicable on the platform without BMC, and neither does FPGA. Please
refer to product sheet / feature sheet for more detail.
The basic scope of DUI test items supposed to be applicable to every platform:

Service 1: CPU

Function 0: cpu_test, CPU burn-in test function

Function 2: pcie_link, PCIe link width and status test function

Function 3: cpu_ver, Verify CPU vendor id, model name, frequency and core count

Service 2: Memory

Function 0: mem_test, Memory pattern test function

Service 4: Ethernet

Function 1: lan_mac, Duplicate MAC address detection

Function 2: eth_id, Ethernet id check function

Service 5: STORAGE

Function 2: benchmark, Storage benchmark

Service 9: RTC

Function 1: rtc_sys, System rtc test function

Service 10: SCRIPT

Function 55: mem_check.sh, To check memory capacity, frequency, number of
DIMMs
On the other hand, for specific test items, DUI service 10 supports scripting diagnostic on
demand, which is not covered in this guide since it's created from customization
requirement.
Proceed with the following commands to execute the cpu_ver function of the CPU diagnostic
service as an example, wait until the command execution completes then check the test
result with the 'log' command
dependent and shall be modified to match your Advantech platform configuration):
cli> start 1 3 cpu_id=GenuineIntel cpu_model=N4200 frequency=1.10 core_count=4
start the function 3 of service 1 ...
start function OK.
cli> wait 1 3
wait function completed.
wait function OK.
cli> log 1 3
Copyright 2017. All rights reserved. Advantech Co. Ltd.
(Please note that function parameters are platform
Page 66