Table of Contents
Advertisement
VLT Ea4 Parallel Drive Modules
Operating Guide
1
Typecode
2
Part number and serial number
2.2 Lifting the Drive Module
The drive modules are heavy and failure to follow local safety regulations for lifting heavy weights may cause death, personal
injury, or property damage.
-
Ensure that the lifting equipment is in proper working condition.
-
Check the weight of the module and verify that the lifting equipment can safely lift the weight.
-
Always lift the drive using a lifting bar inserted into the lifting eyes. Maximum diameter for the lifting bar: 20mm (0.8 in).
-
The angle from the top of the drive to the lifting cable: 60° or greater.
-
Test lift the unit approximately 610 mm (24 in) to verify the proper center of gravity lift point. Reposition the lifting point if
the unit is not level.
Illustration 3: Drive Module Lifting Technique
2.3 Storage
Store the kit in a dry location. Keep the equipment sealed in its packaging until installation. Refer to
Drive Modules
for recommended ambient conditions during storage and use.
Danfoss A/S © 2023.01
3
Intended use disclaimer
4
Discharge time
W A R N I N G
Receiving the Drive
7.5 Ambient Conditions for
AQ434333248451en-000101 / 130R1286 | 11
Advertisement
Table of Contents
