Danfoss VLT Ea4 Operating Manual page 43

VLT Ea4 Parallel Drive Modules
Operating Guide
Status
799RPM
Auto Remote
Hand Local
Off
1
2
3
Illustration 24: Status Display
1 See 6.8.2 Status Messages - Operating
2 See 6.8.3 Status Messages - Reference
6.8.2 Status Messages - Operating Mode
Table 15: Operating Mode
Operating Description
mode
Auto The drive requires external commands to execute functions. The start/stop commands are sent via the control
terminals and/or the serial communication.
Hand The navigation keys on the LCP can be used to control the drive. Stop commands, reset, reversing, DC brake,
and other signals applied to the control terminals override local control.
Off The drive does not react to any control signal until [Auto On] or [Hand On] is pressed.
6.8.3 Status Messages - Reference Site
Table 16: Reference Site
Reference site
Remote
Local
6.8.4 Status Messages - Operation Status
Table 17: Operation Status
Operation Description
status
AC brake AC brake was selected in parameter 2-10 Brake Function. The AC brake overmagnetizes the motor to achieve a
controlled slow down.
AMA finish Automatic motor adaptation (AMA) was carried out successfully.
OK
Danfoss A/S © 2023.01
1(1)
7.83A 36.4kW
0.000
53.2%
Ramping
Stop
Running
Jogging
.
.
.
Standby
Mode.
Site.
Description
The speed reference is given from:
• External signals.
• Serial communication.
• Internal preset references.
The drive uses reference values from the LCP.
3 See 6.8.4 Status Messages - Operation
AQ434333248451en-000101 / 130R1286 | 43
Operating the Drive
Status.