Unpackintg; Design Characteristics (Fig.6; 7; 8; 9) - TESY AquaThermica Compact HPWH 3.2 100 Installation And Maintenance Manual

3.2.

Unpackintg

The unpacking operations must be carried out carefully so as not to damage the appliance.
Please follow the described steps bellow Fig.3:
- Using a cutter, cut the straps 7.
- Pull upwards the cartoon box 1.
- Remove the upper EPS plate 2
- Gently take the appliance out of the cartoon tray 4
After having removed the packaging, make sure that the unit is intact. If in doubt, do not use the equipment and seek help from
authorized technical staff.
In conformity with environmental protection regulations, make sure that all the accessories supplied have been removed
before discarding the packaging.
After having removed the packaging, make sure that the unit is intact. If in doubt, do not use the equipment and seek help
from authorized technical staff.
In conformity with environmental protection regulations, make sure that all the accessories supplied have been removed
before discarding the packaging.
WARNING!:
they are dangerous.
Note: at the manufacturer's discretion, the type of packaging may be subject to change.
WARNING!:
product handling and installation stages because it is not of a structural nature. (Please see Fig.4 & Fig.5)
WARNING!:
(Please see Fig. 4 & Fig. 5)

4. DESIGN CHARACTERISTICS (Fig.6; 7; 8; 9)

Pos. Description
1
2 Compressor
3 Electronically regulated expansion valve
4
Low pressure safety switch - refrigerant
5
High pressure safety switch - refrigerant
6
Two-way valve (defrost)
7 Filling Needle - High pressure
8 Filling Needle - low pressure
9 Condenser inlet (High pressure)
10 Condenser outlet (Low pressure)
11
Centrifugal fan
13
Bolts M6
14 Upper plastic cover
15 Back and lateral plastic shells
16 Front plastic shell
17 Controller box cover
19
Condenser compressor
20 Transformer
21 Condenser fan
22 Main PCB
Packaging items (staples, cardboard boxed, etc.) must not be left within the reach of children as
It is not permitted to place the upper component of the device under any form of stress during the
While handling, do not catch the unit onto upper plastic panels! There is a risk to damage them!
Pos. Description
27
Lower tank temperature sensor
28 Wall hung brackets
29 Magnesium anode
30
Dielectric sleeve Mg anode
31
Flange seal
32
Flange cover
33 Bolts for flange
34 Manually reset safety thermostat (90oC)
35 Cover
36 E-Heater
37
Hot water feeding pipe
38
Cable terminal
39 Cable clamp
40 Inlet jet pipe ('piston" effect) – part 1
43 Inlet jet pipe ('piston" effect) – part 2
44 Inlet jet pipe ('piston" effect) – "O" ring
45
Inlet jet pipe ('piston" effect) – part 3
46 Condensator
47 Heat insulation
48 Safety thermo switch 80
10
C (automatic reset)
o