Download Print this page
Transition Networks E-100BTX-FX-04(LH) User Manual

Transition Networks E-100BTX-FX-04(LH) User Manual

100base-tx/100base-fx media converters

Advertisement

Quick Links

COMPLIANCE INFORMATION

UL Listed
C-UL Listed (Canada)
CISPR/EN55022 Class A
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user's own expense.
Canadian Regulations
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on
the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables
aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique
édicté par le ministère des Communications du Canada.
European Regulations
Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Achtung !
Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes
Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen
werantwortlich ist.
Attention !
Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l'utilsateur de prende les measures spécifiques
appropriées
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
Trademark Notice
All registered trademarks and trademarks are the property of their respective owners.
Copyright Restrictions
© 1998-2000 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
Printed in the U.S.A.
The TRANSITION Networks E-100BTX-FX-04 series Ethernet™ 100BASE-TX to
100BASE-FX media converters connect 100BASE-TX unshielded twisted pair cable
to 100BASE-FX multimode OR singlemode fiber-optic cable.
E-100BTX-FX-04
Provides an RJ-45 twisted pair
100BASE-TX connector and a set of
RX (receive) and TX (transmit) ST
100BASE-FX connectors to 1300 nm
multimode fiber-optic cable.
E-100BTX-FX-04(SC)
Provides an RJ-45 twisted pair
100BASE-TX connector and an RX
(receive) and TX (transmit) SC
100BASE-FX connector to 1300 nm
multimode fiber-optic cable.
E-100BTX-FX-04(MT)
Provides an RJ-45 twisted pair
100BASE-TX connector and an RX
(receive) and TX (transmit) MT-RJ
100BASE-FX connector to 1300 nm
multimode fiber-optic cable.
E-100BTX-FX-04(SM)
Provides an RJ-45 twisted pair
100BASE-TX connector and an RX
(receive) and TX (transmit) SC
100BASE-FX connector to 1300 nm
singlemode fiber-optic cable.
E-100BTX-FX-04(SMLC)
Provides an RJ-45 twisted pair
100BASE-TX connector and an RX
(receive) and TX (transmit) LC
100BASE-FX connector to 1300 nm
singlemode fiber-optic cable.
33057.H
100BASE-TX/100BASE-FX
Media Converters
E-100BTX-FX-04
USER'S GUIDE
4
3
2
1
MDI-X
Switches
Config
E-100BTX-FX-04(LH)
Provides an RJ-45 twisted pair
100BASE-TX connector and an RX
(receive) and TX (transmit) SC
100BASE-FX connector to 1300 nm
singlemode fiber-optic cable.
E-100BTX-FX-04(XL)
Provides an RJ-45 twisted pair
100BASE-TX connector and an RX
(receive) and TX (transmit) SC
100BASE-FX connector to 1310 nm
singlemode fiber-optic cable.
E-100BTX-FX-04(LW)
Provides an RJ-45 twisted pair
100BASE-TX connector and an RX
(receive) and TX (transmit) SC
100BASE-FX connector to 1550 nm
singlemode fiber-optic cable.
E-100BTX-FX-04 in the Network . . . . .2
Installation . . . . . . . . . . . . . . . . . . . .3
Operation . . . . . . . . . . . . . . . . . . . . .4
Fault Isolation and Correction . . . . .5
Cable Specifications . . . . . . . . . . . . .6
Technical Specifications . . . . . . . . . .7
Compliance Information . . . . . . . . . .8
MDI

Advertisement

loading
Need help?

Need help?

Do you have a question about the E-100BTX-FX-04(LH) and is the answer not in the manual?

Questions and answers

Summary of Contents for Transition Networks E-100BTX-FX-04(LH)

  • Page 1: Compliance Information

    Printed in the U.S.A. 100BASE-TX/100BASE-FX USER’S GUIDE The TRANSITION Networks E-100BTX-FX-04 series Ethernet™ 100BASE-TX to 100BASE-FX media converters connect 100BASE-TX unshielded twisted pair cable to 100BASE-FX multimode OR singlemode fiber-optic cable. E-100BTX-FX-04 Provides an RJ-45 twisted pair 100BASE-TX connector and a set of...
  • Page 2: Copper Cable

    Do NOT connect media converters between hubs. Install no more than two (2) 100 meters media converters in series. Switches at the side of the media converter are used to configure the media converter for the network. MDI/MDI-X SWITCH Allows straight-through twisted-pair cable to be used for crossover 100BASE-TX connections.
  • Page 3: Cable Specifications

    CABLE SPECIFICATIONS The physical characteristics of the media cable must meet or exceed IEEE 802.3 specifications. Fiber Cable Bit error rate: 10-9 MULTIMODE Fiber Optic Cable Recommended: 62.5 / 125 µm multimode fiber Optional: 100 / 140 µm multimode fiber 85 / 125 µm multimode fiber 50 / 125 µm multimode fiber E-100BTX-FX-04...
  • Page 4 OPERATION After installation, the media converter should function without operator intervention. Status LEDs: Use the status LEDs to monitor media converter operation in the network. Power Illuminated green LED indicates connection to external AC power. Signal Detect/Fiber: Steady green LED indicates fiber port is connected to device.

This manual is also suitable for:

E-100btx-fx-04(lw)E-100btx-fx-04(mt)E-100btx-fx-04(sc)E-100btx-fx-04(sm)E-100btx-fx-04(smlc)E-100btx-fx-04(xl) ... Show all