Transition Networks CSETF1011 User Manual

Csetf10 series 10base-t/100base-tx to 10base-fl/100base-sx slide-in-module media converters

Advertisement

COMPLIANCE INFORMATION

UL Listed , C-UL Listed (Canada)
CISPR/EN55022 Class A & B
CE Mark
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A & B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user's own expense.
Canadian Regulations
This digital apparatus does not exceed the Class A & B limits for radio noise for digital apparatus set out
on the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables
aux appareils numériques de la class A & B prescrites dans le Règlement sur le brouillage radioélectrique
édicté par le ministère des Communications du Canada.
European Regulations
Warning
This is a Class A & B product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
Achtung !
Dieses ist ein Gerät der Funkstörgrenzwertklasse A & B. In Wohnbereichen können bei Betrieb dieses
Gerätes Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende
Gegenmaßnahmen werantwortlich ist.
Attention !
Ceci est un produit de Classe A & B. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l'utilsateur de prende les measures spécifiques
appropriées
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
Trademark Notice
All registered trademarks and trademarks are the property of their respective owners.
Copyright Restrictions
© 2000, 2002 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
Printed in the U.S.A.
10BASE-T/100BASE-TX to 10BASE-FL/100BASE-SX
TRANSITION Networks CSETF10xx series Ethernet™ and Fast Ethernet™ media
converters, designed to be installed in a PointSystem
connect 10BASE-T or 100BASE-TX shielded or unshielded twisted-pair copper
cable to 850 nm 10BASE-FL or 850 nm 100BASE-SX multimode fiber-optic cable.
Media
Conversion
Center
Power
1
In Use
Power
2
In Use
MCCM10
MGMT MASTER
CSETF1011
Provides an RJ-45 twisted pair
10BASE-T/100BASE-TX connector
and a set of RX (receive) and TX
(transmit) ST 10BASE-FL/100BASE-
SX connectors to 850 nm
multimode fiber-optic cable.
CSETF1013
Provides an RJ-45 twisted pair
10BASE-T/100BASE-TX connector
and an RX (receive) and TX
(transmit) SC 10BASE-FL/100BASE-
SX connector to 850 nm multimode
fiber-optic cable.
*In the CSETF10xx model designation,10
represents the 10BASE-T/100BASE-TX RJ-45
connector; xx represents the selectable
10BASE-FL/100BASE-SX fiber connector
33177.D
installed on the media converter.
Slide-In-Module Media Converters
CSETF10xx
USER'S GUIDE
PWR
PWR
PWR
PWR
PWR
PWR
SPD
PWR
PWR
PWR
LKF
PWR
LKS
LKS
LKS
LA
LKS
LKS
SPD
PWR
LNK
LNK
FRX
FLNK
RXF
LKM
LKM
LKM
RXF
LKM
LKM
FRX
FLNK
CRX
CLNK
RXC
LKC
RXC
COL
COL
CRX
CLNK
TX
TX
TX
TX
TX
Link Alert
Link
Alert
TX
TX
E
D
TX
RESET
RX
RX
RX
RX
RX
RX
RX
TX
TX
TX
TX
TX
RX
TX
PWR
0
50
50‰
RX
LNK
RX
RX
RX
RX
RX
CETTF100
CFMFF100
CFMFF100
CFETF100
CECF100
CECF100
CFMFF100
CFMFF100
CFETF110
CFMFF100
CFMFF100
CSETF1018
Provides an RJ-45 twisted pair
10BASE-T/100BASE-TX connector
and an MT-RJ 10BASE-FL/100BASE-
SX connector to 850 nm multimode
fiber-optic cable.
CSETF10xx in the Network . . . . . . . . .2
Installation . . . . . . . . . . . . . . . . . . . .5
Operation . . . . . . . . . . . . . . . . . . . . .6
Fault Isolation and Correction . . . . .8
Cable Specifications . . . . . . . . . . . .10
Technical Specifications . . . . . . . . .11
Compliance Information . . . . . . . . .12
Conversion Center
PWR
PWR
PWR
PWR
PWR
PWR
LKS
LKS
LA
LKS
LKS
LNK
LNK
LKM
LKM
RXF
LKM
LKM
RXC
COL
COL
TX
TX
TX
TX
Link
Link Alert
Alert
E
D
RX
RX
RX
RX
TX
TX
TX
TX
0
50
50‰
RX
RX
RX
RX
CFMFF100
CFMFF100
CETCF100
CETCF100
CFMFF100
CFMFF100

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CSETF1011 and is the answer not in the manual?

Questions and answers

Summary of Contents for Transition Networks CSETF1011

  • Page 1: Compliance Information

    Power In Use RESET MCCM10 MGMT MASTER CETTF100 CFMFF100 CFMFF100 CSETF1011 Provides an RJ-45 twisted pair 10BASE-T/100BASE-TX connector and a set of RX (receive) and TX (transmit) ST 10BASE-FL/100BASE- SX connectors to 850 nm multimode fiber-optic cable. CSETF1013 Provides an RJ-45 twisted pair...
  • Page 2: Network Configurations

    10/100 auto-negotiating ports to provide reliable 10 Mb/s or 100 Mb/s fiber links. Network Configurations Install two CSETF10xx series media converters in series to extend, over fiber, the distance between two 10BASE-T or two 100BASE-TX devices: Media Conversion...
  • Page 3: Cable Specifications

    CABLE SPECIFICATIONS The physical characteristics of the media cable must meet or exceed IEEE 802.3 specifications. Fiber Cable MULTIMODE Fiber Optic Cable Recommended: 62.5 / 125 µm multimode fiber Optional: 100 / 140 µm multimode fiber 85 / 125 µm multimode fiber 50 / 125 µm multimode fiber Wavelength : 850 nM...
  • Page 4 CSETF10XX IN THE NETWORK Media Converter in Full-Duplex Network In a full-duplex network, maximum cable lengths are determined by the cables used. See page 10 for cable specifications. NOTE: THE 512-BIT RULE DESCRIBED BELOW DOES NOT APPLY IN A FULL-DUPLEX NETWORK. Media Converter in Half-Duplex Network NOTE: The 512-Bit Rule applies separately to each collision domain.
  • Page 5: Fault Isolation And Correction

    FAULT ISOLATION and CORRECTION If the media converter fails, isolate and correct the fault by determining the answers to the following questions and then taking the indicated action: Is the P(o)W(e)R LED on the media converter illuminated? • Is the media converter inserted properly into the chassis? •...
  • Page 6: Operation

    INSTALLATION (continued) Power the Slide-In-Module NOTE: The Slide-In-Module is powered through the Center ™ OPERATION Using Status LEDs Use the status LEDs to monitor media converter operation in the network. (Speed) Dark LED indicates 10 Mb/s operation. Slow blinking LED indicates speed is not yet selected.

This manual is also suitable for:

Csetf1018Csetf1013

Table of Contents