Transition Networks CFETF1011-200 User Manual

Cfetf10xx*-200 series 100base-tx to 100base-fx slide-in-module media converters

Advertisement

COMPLIANCE INFORMATION

UL Listed
C-UL Listed (Canada)
CISPR/EN55022 Class A & B
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A & B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user's own expense.
Canadian Regulations
This digital apparatus does not exceed the Class A & B limits for radio noise for digital apparatus set out
on the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables
aux appareils numériques de la class A & B prescrites dans le Règlement sur le brouillage radioélectrique
édicté par le ministère des Communications du Canada.
European Regulations
Warning
This is a Class A & B product. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
Achtung !
Dieses ist ein Gerät der Funkstörgrenzwertklasse A & B. In Wohnbereichen können bei Betrieb dieses
Gerätes Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende
Gegenmaßnahmen werantwortlich ist.
Attention !
Ceci est un produit de Classe A & B. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l'utilsateur de prende les measures spécifiques
appropriées
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
Trademark Notice
All registered trademarks and trademarks are the property of their respective owners.
Copyright Restrictions
© 2000, 2001 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
Printed in the U.S.A.
TRANSITION Networks CFETF10xx series Fast Ethernet
designed to be installed in a
100BASE-TX shielded or unshielded
twisted-pair copper cable to 100BASE-FX
multimode or singlemode
cable.
CFETF1011-200
Provides an RJ-45 twisted-pair copper
100BASE-TX connector and a set of RX
(receive) and TX (transmit) ST 100BASE-FX
connectors to multimode 1300 nm fiber-
optic cable.
CFETF1013-200
Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) MM-SC
100BASE-FX connector to multimode
1300 nm fiber-optic cable.
CFETF1014-200
Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) SC 100BASE-FX
connector to singlemode 1300 nm fiber-
optic cable.
CFETF1015-200
Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) SC 100BASE-FX
connector to singlemode 1300 nm fiber-
optic cable.
*In CFETF10xx model designation, 10
represents the100BASE-TX RJ-45 connector;
xx represents the selectable fiber connector
installed on the media converter.
33171.C
100BASE-TX to 100BASE-FX
Slide-In-Module Media Converters
CFETF10xx*-200
USER'S GUIDE
PointSystem
Conversion Center
fiber-optic
Media
Conversion
Center
Power
1
In Use
Power
2
In Use
RESET
TX
PWR
RX
LNK
MCCM10
MGMT MASTER
CFETF1016-200
Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) SC 100BASE-FX
connector to singlemode 1300 nm fiber-
optic cable.
CFETF1017-200
Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) SC 100BASE-FX
connector to singlemode 1550 nm fiber-
optic cable.
CFETF1018-200
Provides an RJ-45 twisted-pair copper
100BASE-TX connector and an RX
(receive) and TX (transmit) MT-RJ
100BASE-FX connector to multimode
1300 nm fiber-optic cable.
CFETF10xx in the Network . . . . . . . . .2
Installation . . . . . . . . . . . . . . . . . . . .5
Operation . . . . . . . . . . . . . . . . . . . . .6
Fault Isolation and Correction . . . . .8
Cable Specifications . . . . . . . . . . . . .9
Technical Specifications . . . . . . . . .11
Compliance Information . . . . . . . . .12
media converters,
,
connect
PWR
PWR
PWR
PWR
PWR
SPD
PWR
PWR
PWR
PWR
LKS
LKS
LA
LKS
SPD
PWR
LKS
LA
LKS
LKF
LNK
LNK
FLNK
RXF
LKM
LKM
FRX
RXF
LKM
FRX
FLNK
LKM
RXF
LKM
RXC
LKC
CRX
CLNK
RXC
COL
CRX
CLNK
RXC
COL
TX
TX
TX
TX
TX
Link Alert
Link Alert
TX
E
D
TX
E
D
TX
RX
RX
RX
RX
RX
RX
RX
TX
TX
TX
RX
TX
TX
0
50‰
0
50‰
RX
RX
RX
RX
RX
CETTF100
CFMFF100
CFMFF100
CFETF100
CECF100
CFMFF100
CFETF110
CFMFF100
CETCF100
CFMFF100

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CFETF1011-200 and is the answer not in the manual?

Questions and answers

Summary of Contents for Transition Networks CFETF1011-200

  • Page 1: Compliance Information

    100BASE-TX shielded or unshielded twisted-pair copper cable to 100BASE-FX multimode or singlemode cable. CFETF1011-200 Provides an RJ-45 twisted-pair copper 100BASE-TX connector and a set of RX (receive) and TX (transmit) ST 100BASE-FX connectors to multimode 1300 nm fiber- optic cable.
  • Page 2: Technical Specifications

    10. Fast Ethernet duplex mode requires attention to the 512-bit Rule. (See page 3.) Network Configurations Install two CFETF10xx series media converters in series to extend, over fiber, the distance between two 100BASE-TX devices: Media...
  • Page 3: Cable Specifications

    CABLE SPECIFICATIONS (continued) Copper Cable Category 5 twisted-pair copper wire is required. Either shielded twisted-pair (STP) or unshielded twisted-pair (UTP) can be used. DO NOT USE FLAT OR SILVER SATIN WIRE. CATEGORY 5: Gauge 24 to 22 AWG Attenuation 22.0 dB /100m @ 100 MHz Maximum Cable Distance: 80 meters The two active pairs in an Ethernet™...
  • Page 4: Installation

    INSTALLATION CAUTION: Wear a grounding device and observe electrostatic discharge precautions when setting switch and when installing Media Converter Slide-in- Module in the Media Conversion Center. Failure to observe this caution could result in damage to, and subsequent failure of, the Media Converter Slide-in- Module.
  • Page 5: Fault Isolation And Correction

    FAULT ISOLATION and CORRECTION If the media converter fails, isolate and correct the fault by determining the answers to the following questions and then taking the indicated action: Is the P(o)W(e)R LED on the media converter illuminated? • Is the media converter inserted properly into the chassis? •...
  • Page 6: Operation

    OPERATION Using Status LEDs Use the status LEDs to monitor media converter operation in the network. P(o)W(e)R Steady LED indicates connection to external AC power. (Fiber link) Steady LED indicates fiber link connection. Flashing LED indicates reception of Far End Fault (FEF) on fiber link. (Fiber receive) Flashing LED indicates reception of data on fiber link.

This manual is also suitable for:

Cfetf1013-200Cfetf1014-200Cfetf1015-200Cfetf1016-200Cfetf1017-200Cfetf1018-200 ... Show all

Table of Contents