Subscribe to Our Youtube Channel
Related Manuals for Akuvox X912
Summary of Contents for Akuvox X912
- Page 1 X912 Quick Guide Unpacking Before you begin using the device, please check the version you got and ensure that the following items are included in the shipped box: M4X10 crosshead screw x5 Rotary bracket x1...
- Page 2 X912 Installation As figure shown, mark four screw holes on the position that according to the cable place. The horizontal distance of two holes should Insert the four plastic wall anchors into the drilled holes. be 50 mm, and the vertical distance of two holes should be 180 mm.
- Page 3 X912 Rotate left in 30 degrees Rotate right in 30 degrees Place the rotary bracket closely against the wall while lining up its four holes with their corresponding drilled holes. And then fasten the rotary bracket on the wall by tightening four ST4x20 crosshead screws to the plastic wall anchors.
- Page 4 Information contained in this document is believed to be accurate and reliable at the time of printing. This document is subject to change without notice, any update to this document can be viewed on Akuvox’ s website: http://www.akuvox.com © Copyright 2022 Akuvox Ltd. All...
Need help?
Do you have a question about the X912 and is the answer not in the manual?
Questions and answers