Mercedes-Benz EQS 2021 Operator's Manual page 672

670 Wheels and tyres
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated until they are
finger-tight.
Unscrew and remove the centring pin.
#
Tighten the last wheel bolt until it is finger-
#
tight.
Lower the vehicle ( page 670).
/
#
Lowering the vehicle after a wheel change
Requirements:
The new wheel has been fitted (
R
* NOTE Risk of vehicle jack becoming trap-
ped by the AIRMATIC system
If the AIRMATIC system has released air when
raising the vehicle, the jack can become trap-
ped when the vehicle is lowered.
Start the drive system. This adapts the
#
vehicle level.
Remove the jack from under the vehicle.
#
To lower the vehicle: place the ratchet onto
#
the hexagon nut of the jack so that the letters
"AB" are visible and turn anti-clockwise.
page 669).
/
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
an initial maximum force of 80 Nm.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
the specified tightening torque of 150 Nm.
& WARNING Risk of accident due to incor-
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed torque.
#
#
#
1 to 5 with
%
1 to 5 with
#
ohne
rect tightening torque
Ensure that the wheel bolts or wheel
nuts are tightened to the prescribed
tightening torque.
If you are not sure, do not move the vehi-
cle. Contact a qualified specialist work-
shop and have the tightening torque
checked immediately.
Check the tyre pressure of the newly fitted
wheel and adjust it if necessary.
The following does not apply if the new wheel
is an emergency spare wheel.
Vehicles with a tyre pressure monitoring sys-
tem: restart the tyre pressure monitoring sys-
tem ( page 660).
/