Mercedes-Benz EQS 2021 Operator's Manual page 668

666 Wheels and tyres
Fitting/removing the hub cap
Removing
Remove socket 2 and wheel wrench
#
the vehicle tool kit.
2 on hub cap 1.
Position socket
#
Position wheel spanner 3 on socket 2.
#
Using wheel spanner 3, turn hub cap
#
anti-clockwise and remove it.
Fitting
Before fitting, check hub cap
#
wheel area for dirt, and clean if necessary.
Position hub cap
#
right position.
Position socket
#
Position wheel wrench
#
tighten hub cap 1.
%
Specified tightening torque: 25 Nm
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change (
3 from
Important notes on using the jack:
Use only a vehicle-specific jack that has been
R
approved by Mercedes-Benz to raise the vehi-
cle.
1
The jack is only designed for raising and hold-
R
ing the vehicle for a short time while a wheel
is being changed and not for maintenance
1 and the
work under the vehicle.
1 and turn until it is in the
2 on hub cap 1.
3 on socket 2
page 665).
/
ohne
The jack must be placed on a firm, flat and
R
non-slip surface. If necessary, use a large, flat,
load-bearing, non-slip underlay.
The foot of the jack must be positioned verti-
R
and
cally under the jack support point.