Mercedes-Benz EQS 2021 Operator's Manual page 662

660 Wheels and tyres
▌Checking the tyre pressure with the tyre pres-
sure monitoring system
Requirements:
The vehicle is switched on.
R
Driver's display:
© Service
4 5
Press a to confirm.
#
One of the following displays appears:
Current tyre pressure of each wheel:
R
Tyre pressures will be displayed after a few
R
minutes of driving: current values are not yet
known to the system. The pressure/tempera-
ture values of each tyre are displayed as soon
as they are known to the system.
Tyre pressure monitor active: the teach-in
R
process of the system is not yet complete. The
tyre pressures are already being monitored.
Compare the current tyre pressure with the
#
recommended tyre pressure for the current
operating condition ( page 658). Addition-
/
ally, observe the notes on cold tyres
( page 657).
/
%
The values displayed in the driver's display
may deviate from those of the tyre pressure
gauge as they refer to sea level. At high eleva-
tions, the tyre pressure values indicated by a
tyre pressure gauge are higher than those
shown in the driver's display.
▌Restarting the tyre pressure monitoring system
Requirements:
The recommended tyre pressure is correctly
R
set for the respective operating status on each
of the four wheels ( page 657).
/
ohne
Restart the tyre pressure monitoring system in the
following situations:
The tyre pressure has changed.
R
The wheels or tyres have been changed or
R
newly fitted.
Driver's display:
© Service
4 5
Tyre pressure
Select and confirm with a.
#
Swipe downwards on Touch Control on the
#
steering wheel.
The Use current tyre pressures as new refer-
ence values? message is shown in the driver's
display.
Select Yes and confirm the restart with a.
#
The Tyre pressure monitor restarted
is shown in the driver's display.
Current warning messages are deleted and
the yellow h warning lamp goes out.
After you have been driving for a few minutes,
the system checks whether the current tyre
pressures are within the specified range. The
current tyre pressures are then accepted as
reference values and monitored.
message