Mercedes-Benz EQS 2021 Operator's Manual page 306

304 Driving and parking
Configuring the charging settings
Multimedia system:
© EQ Charging options
4 5 5
Setting the charging program
You can watch an animation on this topic via the
following link:
Select Home, Work or Standard.
#
Unlocking the charging cable (mode 3 or 4)
When the function is active, the charging cable is
unlocked when the maximum charge level is
reached.
Home or Work.
Select
#
Activate or deactivate Unlock charging
#
Activating or deactivating location-based charging
Select Charge at home or Charge at
#
Activate or deactivate Select based on loca-
#
tion.
When the function is activated, the vehicle's cur-
rent position is saved as one of the selected
options. When the address is reached again, the
charging program is automatically switched over
as soon as parking position P is engaged.
Activating or deactivating ECO charging
Activate or deactivate the function.
#
The ECO charging
voltage at charging stations to conserve the vehi-
cle's battery.
Setting the departure time
The set departure times are used for the vehicle's
pre-entry climate control and for predictions
regarding the approximate state of charge and
range at the time selected. The charging process
always starts immediately, irrespective of the next
cable.
departure time.
Select Departure
#
The following charging times can be selected:
work.
individual charging times
R
one Week profile
R
Setting an individual departure time
Select Add new time
#
time.
function limits the charging
time.
and set a new departure
ohne
or
Select ´ and adapt an existing departure
#
time.
Setting the repeat days
Select Add new time and set a new departure
#
time.
Mark the relevant weekdays for which the
#
departure time will apply and confirm with
a.
or
Select ´ and edit existing repeat days.
#
Setting a break in the charging process
Up to four breaks in the charging process can be
set during which the vehicle is not charged, even
if it is connected to a charging station.
Select Charging interruptions.
#
Select Add new time and then set and save
#
the times for the beginning and end of the
break.
Activate or deactivate the charging breaks that
#
have been set.