Supervisor/User Password - SOLTEK SL-67D Manual

Supervisor/User Password

These two options allows you to set your system passwords.
Normally, supervisor has a higher right to change the CMOS
setup option than the user. The way to set up the passwords
for both Supervisor and User are as follow:
1. Choose ÒChange PasswordÓ in the Main Menu and press
<Enter>. The following message appears:
"Enter Password:"
2. The first time you run this option, enter your password
up to only 8 characters and press <Enter>. The screen
does not display the entered characters.
3. After you enter the password, the following message
appears prompting you to confirm the password:
"Confirm Password:"
4. Enter exact the same password you just typed again to
confirm the password and press <Enter>.
5. Move the cursor to Save & Exit Setup to save the
password.
6. If you need to delete the password you entered before,
choose the Supervisor Password and press <Enter>. It
will delete the password that you had before.
7. Move the cursor to Save & Exit Setup to save the option
you did, otherwise the old password will still be there
when you turn on your machine next time.
8. Press <ESC> to exit to the Main Menu.
Note: If you forget or lose the password, the only way to
access the system is to clear the CMOS RAM by
setting JBAT1. All setup information will be lost and
you need to run the BIOS setup program again.
Award BIOS Setup 41