Table of Contents
Advertisement
The retention clip should be inserted so that the small
rectangle window is more toward to the right hand side of
the board.
If installed incorrectly, you will not be able to insert the CPU
into the retention clip and in this situation you might need
to rotate the retention clip by 180¡.
Tighten the 4 screws on the retention clip till the neck of the
screws can not be seen from the bottom of the board
Step 4:
Pull the latches up on the base of the CPU supporter and
insert it into the two holes directly to the left of the retention
clip so that the larger hole is on the bottom.
Press the base of the CPU supporter down in to the holes
and lock the latches.
10
CPU Heatsink should
be on this side.
Advertisement
Table of Contents
