SOLTEK SL-67D Manual page 43

Primary Choose Auto (default) or Mode 0~4.
The BIOS will detect the HDD Mode
Master/Slave PIO
Secondary type automatically when you
Master/Slave PIO choose Auto. You need to set to a
lower mode than Auto when your
hard disk becomes unstable.
IDE Primary Choose Disabled or Auto (default).
Master/Slave Auto: Automatically detects
UDMA the HDD Ultra DMA
IDE Secondary function.
Master/Slave Disabled: Disabled the HDD Ultra
UDMA DMA function.
Init Display First This item allows you to decide to
active PCI Slot or AGP first
The choice: PCI Slot, AGP.
KBC Input Clock Choose 6MHz, 8MHz (default),
12MHz, or 16MHz. There might be
a compatible problem when is
above 8MHz.
Onboard FDC Choose Enabled (default) or
Controller Disabled. Choose Disabled when
you use an ISA card with FDD
function, or , choose Enabled to use
the onboard FDD connector.
Onboard Serial Choose Auto (default), 3F8/IRQ4 ,
Port 1 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, or
Disabled. Do no set port 1 & 2 to
the same value except for Disabled.
Onboard Serial Choose Auto (default), 3F8/IRQ4 ,
Port 2 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, or
Disabled.
UART Mode select Choose Normal (default), IrDA, or
ASKIR.
Award BIOS Setup 39