Opitec Wind Machine Manual page 5

Instructions 100.803
Wind Machine
18
Cut a 150 mm long piece of round rod and glue on the wind blade (3c)
centered, as shown. Place the stick with the wind blade on the wind
machine bracket with glue.
20
Glue 16 blades (depending on the version) into the wind wheel as
shown.
22
Insert the finished wind turbine into the upper part of the tower as
shown.
5
19
8
Cut out the blades from the cardboard (2) or transfer the dimensions
to the wooden veneer (8). Then carefully cut out of the veneer with a
craft knife.
21
Then glue a 65 mm long round rod into the hole of the cork part (G)
from below.
23
Done!