Mounting Instructions; Power/Signal Connection Procedure - Blizzard Lighting PixlStik Manual

Mounting Instructions

1. Attach the clamp to the mounting bracket.
2. Attach the clamp to the desired structure or surface.
3. Attach a safety cable to the product's safety cable loop.
Series Attachment Instructions
PixlStik™ fixtures can be attached in an end-to-end formation to create a strip
up to 4 meters long (4 fixtures) from just one rigging point.
CAUTION! - Do not connect more than a total of 4 fixtures in a row
when hanging vertically.
1. Loosen the wing nuts on the 1st fixture's connector bracket.
2. Slide the connector bracket out till it stops at the midway point off of the end
of the 1st fixture, and tighten the 1st wing nut to secure the connector bracket
in place.
3. Slide the 2nd fixture onto the connecting bracket and tighten the 2nd wing
nut, then attach the safety cable.
4. Repeat the process to attach more fixtures.

Power/Signal Connection Procedure

PixlStik™ fixtures use an RJ45 connection to link all ports. Each strip can be
linked from end-to-end never exceeding a total of 4 fixtures for each daisy
chain. The following diagram illustrates how to configure the data connections.
Correct
Incorrect
Page 8
PixlStik™ User Manual Rev. A © 2015 Blizzard Lighting, LLC