3. SETUP
Clear/Frost Filter Installation:
The PixlStik™ includes a frost filter already installed. Follow the procedure be-
low to install the clear filter.
1. Locate the end cap of the product.
2. Remove the 4 screws from the end cap of the product.
3. Slide out and remove the installed filter.
4. Slide in the desired filter.
5. Re-install the end cap.
*Be sure to install the frost filter with the shiny side facing toward the LEDs.
Mounting Guidelines
We recommend the following guidelines when mounting:
•
While deciding on a mounting location, be sure there is convenient access
to your fixture(s) for maintenance and programming.
•
Make sure the structure that you are mounting this product to can support
its weight.
•
When mounting overhead, always use a safety cable and mount the unit to
a secure rigging point.
•
When rigging this fixture onto a truss, be sure to use mounting clamps with
appropriate weight capacity ratings.
•
Do not use tools to loosen or tighten the hanging bracket knobs when
adjusting the angle of the fixture. Tighten them manually. Using tools could
damage the knobs.
PixlStik™ User Manual Rev. A
4x Phillips
Head Screws
End Cap
Page 7
© 2015 Blizzard Lighting, LLC