Changing The Lenses; Installing Or Removing Brackets; Mounting & Rigging - Blizzard Lighting Motif Risplendi 150 Manual

Table of Contents

Changing the Lenses

This fixture comes with a pre-installed 80° diffuser lens plus 3x replaceable

Fresnel lenses

for a variety of beam angles.

(30°, 45°, and 60°)

To change the lens, remove the thumbscrew from the lens holder and swivel

the holder outwards. Replace the existing lens with the lens of your choice.

Note: The replaceable lenses need to be installed with the circular pattern side

of the lens facing outwards.

*When using lenses with narrower beam angles, some chromatic aberration

(color separation) may occur. We recommend using the snoot accessory (sold

separately) to cut off the beam edge. This may help in certain circumstances.

Thumbscrew

Lens Holder

Brackets

Snoot

(sold separately)

1.) Install or remove the brackets as shown above us-

ing the included bolts, washers, and knobs.

2.) Use the small bracket for vertically mounted fixed

installations. You can remove the large bracket in these

types of applications, and use the included plastic

plugs to cover the bracket screw holes.

Mounting & Rigging

This fixture may be mounted in any SAFE position pro-

vided there is enough room for ventilation.

Mount the fixture using a suitable "C" or "O" type

clamp. The clamp should be rated to hold at least 10x the fixture's weight to

ensure structural stability. Do not mount to surfaces of unknown strength,

ensure properly rated rigging is used, and always secure your fixtures with a

safety cable.

Page 9

Motif™ Risplendi 150 - Rev. A

Table of Contents