Table of Contents
Advertisement
Fixture Linking (M/S Mode)
1. Connect the male connector side of the DMX cable to the output female
connector of the first fixture.
DMX IN
DMX OUT
Next
Fixture
in Chain
DMX IN
Check the "Operating Adjustments" section in this manual for complete
instructions for this type of setup and configuration.
Mounting & Rigging
This fixture may be mounted in any SAFE position provided there is enough
room for ventilation. The fan or vent pathway must never be obstructed.
IMPORTANT: Regardless of the rigging option you choose for your fixtures,
always be sure to secure your fixture with a safety cable.
Mount the fixture using a suitable "C" or "O" type clamp. The clamps should be
rated to hold at least 10x the fixture's weight to ensure structural stability. Do
not mount to surfaces of unknown strength, and ensure properly rated rigging
is used when mounting fixtures overhead.
Overhead mounting requires extensive experience, which includes calculating
working load limits, knowledge of the installation material being used, and
periodic safety inspections. If you lack these qualifications, do not attempt the
installation yourself. Improper installation can result in bodily injury.
MAX L™ User Manual - Rev. A
2. Connect the end of the cable coming from
First
the first fixture which will have a female
Fixture
in Chain
connector to the input connector of the next
fixture consisting of a male connector. Then,
proceed to connect from the output as stated
above to the input of the following fixture
and so on.
A quick note: Often, the setup for Master-Slave and
Standalone operation requires that the first fixture in the
chain be initialized for this purpose via either settings in the
control panel or DIP-switches. Secondarily, the fixtures that
DMX OUT
follow may also require a slave setting.
Bracket
Page 9
Clamp
Safety Loop
© 2020 Blizzard Lighting, LLC
Advertisement
Table of Contents
