Troubleshooting - Panasonic MX-XP103 Operating Instructions Manual

Troubleshooting

Check following points before calling or arranging for repair.
Problem
Even though
the tumbler is
twisted to
"ON" direction,
the appliance
does not start
blending.
The blade is
idling.
The appliance
stops during
blending.
There is
abnormal
noise or
vibration.
EN14
VN.indb 14 VN.indb 14
The tumbler unit is not attached with the motor housing
●
properly.
➡ When attaching it, make sure the marks on tumbler
▶
base and motor housing have been aligned, then twist
it firmly until you hear a "click" sound.
The tumbler base is not attached tightly.
●
➡ Assemble it tightly.
The power plug is disconnected.
●
➡ Insert the power plug into outlet firmly.
Ingredients are stuck around the blade.
●
➡ Remove all ingredients and then replace them.
The liquid amount is not enough.
●
➡ Add more liquid.
▶
Too much ice cubes.
●
（e.g. juice with a lot of ice）
➡① Twist the tumbler back to "OFF" direction, remove
tumbler after rotation stops completely.
② Shake the tumbler gently.
• If it happens again, reduce the ingredients.
The overloading protection device is activated.
●
• Prohibited ingredients are added.
▶
• Too much ingredients are used.
• Ingredients are too large.
• Ingredients are too hard. (e.g. shaved ice)
• There is abnormal noise or vibration is too large.
➡ Refer to "Overloading Protection" for inspection.(P. EN15)
If prohibited ingredients are used, remove them.
▶
Too much ingredients.
●
➡ Twist tumbler to "OFF" direction and reduce ingredient amount.
The tumbler unit is not assembled firmly.
●
➡ Assemble it firmly. (P. EN8)
Cause and Action
2022-06-01 15:55:18 2022-06-01 15:55:18