Overloading Protection - Panasonic MX-XP103 Operating Instructions Manual

Problem
The mxiture is
leaking.
sing
er
twist
Lubrication oil might be traced around the upper connector (P. EN7) but it will not
●
affect the performance. Wipe them off with kitchen paper.
"Peep" sound may be heard during operation, but it is not abnormal.
●

Overloading Protection

In case of overload and overheating, the protection device is triggered to stop
operation and it is not abnormal. After rotation stops, follow the below steps:
ove
Do not operate the appliance repeatedly without any countermeasure.
●
1
2
EN15)
3
(If appliance still does not operate, contact Panasonic Service Centre for inspection or repair.)
mount.
VN.indb 15 VN.indb 15
The tumbler unit is not assembled firmly.
●
➡ Assemble it firmly. (P. EN8)
The lid gasket or tumbler base gasket is not attached
●
▶
firmly.
➡ Attach it properly.
Foreign matters are adhered around the lid gasket or
●
tumbler base gasket.
➡ Remove the foreign matters.
The tumbler base gasket is damaged.
●
➡ Replace it.
Unplug the appliance and rest for 10 minutes in order to release the
overloading protection.
Twist tumbler back to "OFF" direction, remove it from motor housing.
And reduce the ingredients in tumbler to less than half.
Remove the prohibited ingredients if used.
●
When the blade is stuck with ice cubes, remove them from the
●
tumbler. For the caught ones around the blade, remove them by
flushing water.
For ingredient etc. with high viscosity or low moisture, reduce the
●
ingredients and add more liquid.
Reset the tumbler, start blending again.
Cause and Action
EN15
2022-06-01 15:55:18 2022-06-01 15:55:18