Troubleshooting; Speci Cations - Panasonic MX-EX1011 Operating Instructions Manual

Check following points before calling or arranging for repair.
Problem
Even turn to 1
position, the
appliance
does not start
blending.
Rotation stops
abruptly.
There is abnormal
noise or vibration
increases.
The ingredient is
leaking.
The blade is idling.
Power supply
Power consumption
Rated time
Working capacity
(appro imately)
Dimensions
(appro imately)
Mass. (appro imately)
EN8

Troubleshooting

The blender jug / mill container is not set properly.
➝ Make sure to align the marks on lender ug / mill container and motor housing, then twist
it firml until ou hear a click sound.
The mill container base is not assembled tightly.
➝ Assem le it tightl . (P. EN6
The protection device of overload or overheating is activated.
➝ Refer to Overload and Overheating Protection for inspection. (P. EN7
The power plug is disconnected.
➝ Insert the power plug into outlet firml .
The protection device of overload or overheating is activated.
➝ Refer to Overload and Overheating Protection for inspection. (P. EN7
Too much ingredients.
➝ Reduce ingredient amount.
The mill container base is not assembled tightly.
➝Assem le it tightl . (P. EN6
The mill container base is not assembled tightly.
➝ Assem le it tightl . (P. EN6
The mill gasket is not attached or attached loosely.
➝ Attach it properl .
Foreign matters are attached to the mill gasket.
➝ Remove them.
The mill gasket is damaged.
➝ Contact Panasonic Service Center to replace it.
The liquid amount is not enough.
➝ Add more li uid.
Too much ice cubes. (e.g. uice with a lot of ice
Remove lender ug after rotation stop completel .
➝
Shake the lender ug gentl .

Speci cations

When the blender is used
Continuous operation (Repeat the c cle
of 3 minutes ON and then 1 minute OFF
W
D
H
Cause and Action
220 V
230
1000
173
161
353
1.5
When the dry mill is used
50 Hz
Continuous operation (Repeat the c cle
of 1 minute ON and then 2 minutes OFF
50
148
161
257
1.3