Troubleshooting - Panasonic MX-MG5351 Operating Instructions Manual

Before calling for service, please check through this section.
Problem
The appliance does
not turn on.
Rotation stops
abruptly.
There is abnormal
noise or vibration
increases.
consistency of
the processed
ingredients do not
turn out well.
The ingredient is
leaking.
The blade is idling.
Power supply
Power consumption
Continuous operation (Repeat the cycle of 3
Rated time
Working capacity

Troubleshooting

The blender jug / mill container is not set properly.
The blender jug base / mill container base is not assembled tightly.
The protection device of overload or overheating is activated.
The power plug is disconnected.
The protection device of overload or overheating is activated.
The Rubber Feet and/or the work top are not clean.
flat surface.
Too much ingredients.
The blender jug base / mill container base is not assembled tightly.
Some ingredients might be too difficult to process raw, e.g. pumpkin.
Ingredient size is not according to the preparation method.
The blender jug base / mill container base is not assembled tightly.
The blender gasket / mill gasket is not attached or attached loosely.
Attach it properly.
Foreign matters are stucked around blender gasket / mill gasket.
The blender gasket / mill gasket is damaged.
The liquid amount is not enough.
Too much ice cubes.
Blender
MX-MG5351
Cause and Action
/
Wet & Dry Mill
Continuous operation (Repeat the cycle of 1
Dry