Troubleshooting - LifeSpan Viper M4 User Manual

XII. TROUBLESHOOTING
PROBLEM
Treadmill will not
start
Running belt not
centered
Computer not
working
E0 1
E02
E03
E04
E05
E06
32

| TROUBLESHOOTING

POSSIBLE CAUSE
Not plugged in
Safety Key not inserted
Running belt tension not
correct on the left or right
sides of the running board
Wires from the computer
and bottom control board
not properly connected.
Transformer is damaged
Current overload
protection (Self Protecting
System)
Motor Abnormality
Hardware Overload
Motor Abnormality
The incoming voltage is
too low.
The incoming voltage is
too high.
SUGGESTED ACTION
Plug cord into outlet
Insert Safety Key
Tighten the adjustment bolts on the left and
right side of the rear roller.
Check wire connections from the computer to
the control board.
If the transformer is damaged,
contact customer service.
Restart the treadmill. Check the incoming
voltage to ensure it is correct. Inspect moving
parts of the treadmill to ensure that they are
operating correctly. Check the motor, listen for
strange noise and check for a burning smell.
Replace the motor if necessary. Check the
control board, replace if damaged. Lubricate the
treadmill.
Check the wire of Motor, re-connect the wire.
Check the motor, replace the motor if necessary.
Check the control board, replace if damaged.
Restart the treadmill. Check the incoming
voltage to ensure it is correct. Check whether the
power wire is dropped Check the control board,
replace if damaged.
Check the wire of Motor, re-connect the wire.
Check the motor, replace the motor if necessary.
Check the control board, replace if damaged.
Restart the treadmill. Check the incoming
voltage to ensure it is correct. Check whether the
power wire is dropped.
Restart the treadmill. Check the incoming
voltage to ensure it is correct.