Jøtul GF 370 DV MV Installation And Operation Instruction Manual page 19

Panel Retainer
Paint edge of side panels to match
Figure 7.9. Loosen the panel retainer screws.
Rear Glass Panel
Figure 7.10. Install Rear Glass Panel.
Figure 7.11. Install Side Glass Panels.
Upper
Bracket
black glass.
130102- 1 GF 370 DV MV 2/22
8. Install Burner Media
River Rocks
CAUTION: THE ROCKS ARE FRAGILE! SUPPORT
THE ASSEMBLY FROM THE BOTTOM AND HAN-
DLE CAREFULLY!
1. Engage the River Rock bed with the two center burner
pins as shown in fig. 7.12. Either side of the rocks may
face outward as desired.
2. Evenly disperse the Ember Stones supplied over the
burner plate around the log parts. DO NOT ALLOW
EMBER STONES TO BLOCK THE PILOT ASSEM-
BLY AREA. The carry-over ports directly in front of the
pilot must remain clear for proper pilot ignition. See
figs. 7.16 and 10.3 for examples.
StarFire Glass Embers
Do not use more than the four pounds (in two, 2 lb. bags)
of glass media provided. For best results, evenly spread the
contents of the bag over the entire burner plate and rear
skirt, mounding a crown toward the center.
DO NOT COVER THE AREA IMMEDIATELY IN
FRONT OF THE PILOT ASSEMBLY. The carry-over ports
directly in front of the pilot assembly must be clear to ensure
proper pilot ignition. See fig. 10.3 page 24.
Figure 7.12. Set River Rock assembly on pins.
19