Table of Contents
Advertisement
Replacing a DVD drive
To install the replacement DVD drive, compete the following steps:
1. Slide the DVD drive into the drive bay until the drive engages.
2. Install the top cover (see "Replacing the top cover" on page 42).
3. Connect the cables and power cords (see "Connecting the cables" on page 40
4. Turn on all attached devices and the server.
Removing the power-supply structure
To remove the power-supply structure, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the top cover (see "Removing the top cover" on page 41).
4. Remove all power supplies (see "Removing the hot-swap power supply" on
5. Pull the two blue latches on the structure toward the front of the server; the
6. Grasp the handle in the middle of the structure and lift the structure out of the
7. If you are instructed to return the power-supply structure, follow all packaging
56
IBM System x3755 Type 8877 and 7163: Problem Determination and Service Guide
for cabling instructions).
on page 37.
all external cables necessary to replace the device.
page 46).
structure disengages from the chassis.
server.
instructions, and use any packaging materials for shipping that are supplied to
you.
Latches
Alignment tabs
Handle
Alignment pins
Advertisement
Table of Contents
