Table of Contents
Advertisement
Configuration/Setup Utility menu choices
The following choices are on the Configuration/Setup Utility main menu. Depending
on the version of the BIOS code, some menu choices might differ slightly from
these descriptions.
v System Summary
Select this choice to view configuration information, including the type, speed,
and cache sizes of the microprocessors and the amount of installed memory.
When you make configuration changes through other choices in the
Configuration/Setup Utility program, the changes are reflected in the system
summary; you cannot change settings directly in the system summary.
This choice is on the full and limited Configuration/Setup Utility menu.
– Processor Summary
Select this choice to view information about the microprocessors.
v System Information
Select this choice to view information about the server. When you make changes
through other options in the Configuration/Setup Utility program, some of those
changes are reflected in the system information; you cannot change settings
directly in the system information.
This choice is on the full Configuration/Setup Utility menu only.
– Product Data
Select this choice to view the machine type and model of the server, the serial
number, and the revision level or issue date of the BIOS, diagnostics, and
BMC code that are stored in electrically erasable programmable ROM
(EEPROM).
– System Card Data
Select this choice to view vital product data (VPD) for some server
components.
v Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output
(I/O) ports.
Select this choice to enable or disable integrated SAS and Ethernet controllers
and all standard ports (such as serial). Enable is the default setting for all
controllers. If you disable a device, it cannot be configured, and the operating
system will not be able to detect it (this is equivalent to disconnecting the
device).
This choice is on the full Configuration/Setup Utility menu only.
– Remote Console Redirection
Select this choice to enable Serial over LAN (SOL) and to set remote console
communication parameters.
– Video
Select this choice to view information about the integrated video controller.
– IDE Configuration Menu
Select this choice to enable or disable the IDE controller.
– System MAC Addresses
Select this choice to view the Ethernet 1 controller and Ethernet 2 controller
MAC addresses.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
Chapter 2. Configuration information and instructions
15
Advertisement
Table of Contents
